Skip to main content
NetApp Knowledge Base

Error message: Aggregate Snapshot copies are used in SyncMirror aggregate. That is not recommended

  1. Last updated
  2. Save as PDF
Views:
1,455
Visibility:
Public
Votes:
1
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

​ ​

Applies to

  • ONTAP 9
  • Data ONTAP 8.2 (7-mode)
  • MetroCluster

Issue

Check Active IQ if this impacts your systems

After the successful creation of a new aggregate that was created as a sync mirror of an existing aggregate, the following warning error message is reported:

Tue Nov 10 07:00:00 EST [filer1: raid.mirror.aggrSnapUse:warning]: Aggregate Snapshot copies are used in SyncMirror aggregate 'aggr1'. That is not recommended.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.