Skip to main content
NetApp Knowledge Base

What are the steps to update ONTAP's Service Processor (SP) or Baseboard Management Controller (BMC)

Last Updated:

Applies to

  • Service Processor (SP)
  • Baseboard Management Controller (BMC)
  • ONTAP 9


Installation prerequisites

To install the BMC/SP image, you need to have access to the following devices:

  • A web server on a network accessible to your storage controller
  • A serial console connected to the storage controller

You can use either the ONTAP CLI or the BMC/SP CLI to update the firmware. However, you must not use both CLIs at the same time to trigger an update.

Note: The ONTAP CLI is the preferred download method.


Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.