Skip to main content
NetApp Knowledge Base

Why interconnect device is not list from sldiag device show

  1. Last updated
  2. Save as PDF
Views:
83
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
hw
Last Updated:

Applies to

FAS9000

Answer

In order to have sldiag interconnect devices, Both filers need to be booted with "boot_diags" and "sysconfig -v" shows the link state of both interconnect ports (port 1 & port 2) on both filers are "ACTIVE".

Additional Information

additionalInformation_text
NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device