Skip to main content
NetApp Knowledge Base

System panics when running sldiag commands after Flash Cache NVME replacement

Views:
251
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

  • FAS9000
  • ONTAP 9.7P3

Issue

System panics when trying to run sldiag commands after replacing the Flash Cache NVME device.

Messages such as the below can be observed:
*> sldiag device run -dev fcache
Initializing . . .
PANIC : page fault (supervisor read data, page not present) on VA 0x58 cs:rip 0x20:0xffffffff87cb14b3 rflags 0x10246version: 9.7P3: Fri Apr 17 10:40:14 EDT 2020
*> sldiag device clearstatus
Initializing . . .
PANIC : page fault (supervisor read data, page not present) on VA 0x58 cs:rip 0x20:0xffffffff87cb14b3 rflags 0x10246version: 9.7P3: Fri Apr 17 10:40:14 EDT 2020
PANIC: page fault (supervisor read data, page not present) on VA 0x58 cs:rip 0x20:0xffffffff87cb14b3 rflags 0x10246 in SK process rc on release 9.7P3 (C) on Wed Jun 3 21:08:32 GMT 2020version: 9.7P3: Fri Apr 17 10:40:14 EDT 2020

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device

 

  • Was this article helpful?