Skip to main content
NetApp Knowledge Base

System is at high risk of unexpected behavior if dynamically qualified drives are detected

Views:
2,315
Visibility:
Public
Votes:
0
Category:
disk-drives
Specialty:
hw
Last Updated:

Applies to

Disk Drives

Issue

Check Active IQ if this impacts your systems

In certain scenarios resources like Hardware Universe or the disk fw download page will show a current version of ONTAP as supported with a drive type however the following symptoms could be seen:

  • Drive type not reporting the appropriate size.
  • Drives not being partitioned appropriately and used as spares to replace failing data drive partitions
  • Drives marked as "dynamically qualified: yes" when reviewed via the (7-mode or nodeshell) storage show disk or (cluster) storage disk show -error-type qualfail commands.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device