Skip to main content
NetApp Knowledge Base

System Timeout Setting for BMC SSH session seems to be ignored

Views:
479
Visibility:
Public
Votes:
0
Category:
aff-series
Specialty:
hw
Last Updated:

Applies to

  • ONTAP 9
  • AFF A250
  • CLI

Issue

CLI timeout settings 0, 1-10, >10 have no impact:

cluster1::> system timeout modify -timeout 0

value is equal 0  ==> disconnect without notice after 10min. idle time

cluster1::> system timeout modify -timeout 1

values between 1-10  ==> disconnect with usual notices during the last minute "(Login timeout will occur in 60..50..40..30..20..10 seconds)"

cluster1::> system timeout modify -timeout 11

values >=11  ==> disconnect without notice after 10min. idle time "

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.