Skip to main content
NetApp Knowledge Base

Port e0c e0d e0e e0f can't be identified after power cycle

Views:
611
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
hw
Last Updated:

Applies to

FAS2650

Issue

After power cycle, port e0c e0d e0e e0f can't be identified from sysconfig -a.
 
slot 0: 10 Gigabit Ethernet Controller IX5-SFP+
e0a MAC Address: 00:a0:98:dd:21:07 (auto-10g_twinax-fd-up)
    SFP Vendor: Molex Inc.
    SFP Part Number: 747529718
    SFP Serial Number: XXXXXXXXX
e0b MAC Address: 00:a0:98:dd:21:08 (auto-10g_twinax-fd-up)
    SFP Vendor: Molex Inc.
    SFP Part Number: 747529718
    SFP Serial Number: XXXXXXXXX
 Device Type: X550EM
 Firmware Version: 0.86-7.1 (20150807-0701)
slot 0: PLX DMA Engine 2 (PLX87d0)
 State: Active
slot 0: Interconnect HBA: Generic OFED Provider
 Port Name: ic0a
 GID: XXXX:XXXX:XXXX:XXXX:XXXX:XXXX:XXXX:XXXX
 Base LID: XXXXX
 Active MTU: 8192

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.

 

  • Was this article helpful?