Skip to main content
NetApp Knowledge Base

PSU 5V Curr sensor always shows "0 mA" in normal status

Views:
88
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

  • AFF-A220A
  • ONTAP 9.6p2

Issue

  • "PSU2 5V Curr "sensor always shows "0 mA" in normal status.

Example:

SP-LATEST-IPMI log:
Node-A
----------------------------------------------------------------------------------------------------
PSU1 5V Curr normal 500 mA -- -- -- --
PSU1 12V Curr normal 9840 mA -- -- -- --
PSU2 5V Curr normal 0 mA -- -- -- --
PSU2 12V Curr normal 8550 mA --
----------------------------------------------------------------------------------------------------
 
Node-B
----------------------------------------------------------------------------------------------------
PSU1 5V Curr normal 540 mA -- -- -- --
PSU1 12V Curr normal 9880 mA -- -- -- --
PSU2 5V Curr normal 0 mA -- -- -- --
PSU2 12V Curr normal 8590 mA -- -- -- --
----------------------------------------------------------------------------------------------------
 
  • Upgrade the BMC FW to the latest 11.5 & replace the PSU2 ,but not helpful.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device