Skip to main content
NetApp Knowledge Base

'Mapping Ports' step during headswap fails with "Error: Cannot run this command because the system is not fully initialized."

Views:
1,501
Visibility:
Public
Votes:
2
Category:
aff-series
Specialty:
hw
Last Updated:

Applies to

  • ONTAP 9

Issue

  • During the 'Mapping Ports' step in the headswap guide, commands fail with Error: Cannot run this command because the system is not fully initialized.  Wait a few minutes, and then try the command again.
  • RDB applications will also show offline during this step. This can be verified with the diagnostic command cluster ring show


 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.