Skip to main content
NetApp Knowledge Base

How to identify controller chassis slot position for AFF and FAS models within ONTAP

Views:
472
Visibility:
Public
Votes:
1
Category:
ontap-9
Specialty:
hw
Last Updated:

Applies to

  • ONTAP 9
  • AFF Models
  • FAS Models

Description

NetApp AFF and FAS models are configured within a chassis that can hold up to two controllers.  Depending on the model the configuration will be either a top and bottom controller configuration or left and right controller configuration.  Note:  For left and right configurations it is designated as you are looking at the chassis from the back of the system where the controllers are inserted.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
  • Was this article helpful?