Skip to main content
NetApp Knowledge Base

Event log shows "Controller failover of node_name is not possible: unsynchronized log"

Views:
1,140
Visibility:
Public
Votes:
1
Category:
ontap-9
Specialty:
hw
Last Updated:

Applies to

FAS8080

Issue

The following error message occurs.
 
Thu Feb 18 02:15:06 JST [node2: monitor: monitor.globalStatus.critical:EMERGENCY]: Controller failover of node1 is not possible: unsynchronized log.
 
The interconnect port is at suboptimal speed.
 
Interconnect Port 1:
Port Name: ib0a
Default GID: xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx
Base LID: 0xed4
Active MTU: 4096
Data Rate: 10 Gb/s (4X) SDR
Link State: ACTIVE
QSFP Vendor: Molex Inc.
QSFP Part Number: 112-00374+A0
QSFP Type: Active Optical 5m ID:00
QSFP Serial Number: xxxxxxxxxxxxxx
 
Interconnect Port 2:
Port Name: ib0b
Default GID: xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx
Base LID: 0xed5
Active MTU: 4096
Data Rate: 40 Gb/s (4X) QDR
Link State: ACTIVE
QSFP Vendor: Molex Inc.
QSFP Part Number: 112-00374+A0
QSFP Type: Active Optical 5m ID:00
QSFP Serial Number: xxxxxxxxxxxxxx

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device