Skip to main content
NetApp Knowledge Base

EMS log reports "cf.hwassist.DefaultPrtnrAddr" notice

  1. Last updated
  2. Save as PDF
Views:
77
Visibility:
Public
Votes:
0
Category:
data-ontap-8
Specialty:
hw
Last Updated:

Applies to

Data ONTAP 7-Mode

Issue

ONTAP version upgraded from 8.2.2P2 7-mode to 8.2.5P5 7-mode, the system start to indicates cf.hwassist.DefaultPrtnrAddr notice.
 
[Filer-01:cf.hwassist.DefaultPrtnrAddr:notice]: The system automatically chose 192.xxx.xxx.100 as the hardware-assist partner address. If you want to use a different IP address, change it using the command 'options cf.hw_assist.partner.address'.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device