Skip to main content
NetApp Knowledge Base

Can ONTAP be set to not boot automatically such as after power loss?

Views:
2,205
Visibility:
Public
Votes:
2
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

  • FAS Series
  • AFF Series

Answer

Perform below command in LOADER.

LOADER-A> printenv AUTOBOOT
LOADER-A> setenv AUTOBOOT false
LOADER-A> saveenv
LOADER-A> boot_ontap

Additional Information

By default, AUTOBOOT is true.

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.