Skip to main content
NetApp Knowledge Base

"Active IQ Config Advisor Summary Report " reports "SAS Cabling checks"

Views:
387
Visibility:
Public
Votes:
0
Category:
aff-series
Specialty:
hw
Last Updated:

Applies to

AFF-A700s

ONTAP 9.7P4

Issue

  • "Active IQ Config Advisor Summary Report " reports "SAS Cabling checks".

Example:

Description:SAS Cabling Checks
Severity :High Impact
Details :Three paths found from controller node name:******* to the stack on port 0a. Only multipath and quad-path configurations are supported.

  • "sysconfig -a" log shows  quad-path is normal.

Example:

slot 0: SAS Host Adapter 0a (Avago Technologies SAS3008 rev. 2, SAS, <UP>)
  Firmware rev:      13.00.00.00
  NVDATA rev:        11.02.17.08
  Base WWN:          5:00a098:00e3028:84
  Phy State:         [0] Enabled, 12.0 Gb/s
                     [1] Enabled, 12.0 Gb/s
                     [2] Enabled, 12.0 Gb/s
                     [3] Enabled, 12.0 Gb/s

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.