Skip to main content
NetApp Knowledge Base

SnapMirror Snapshots build up on SnapVault destination in a Mirror-Vault cascade

  1. Last updated
  2. Save as PDF
Views:
517
Visibility:
Public
Votes:
0
Category:
snapmirror
Specialty:
dp
Last Updated:

​ ​

Applies to

  • ONTAP 9.3
  • ONTAP 9.4
  • SnapMirror to SnapVault cascade

Issue

In a SnapMirror to SnapVault cascade configuration, some volumes may be retaining extra (more than one) "snapmirror" snapshot as seen in the volume snapshot show command on the SnapVault destination. These additional snapshots may cause the SnapVault destination to run out of snapshots prematurely.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.