Skip to main content
NetApp Knowledge Base

7MTT precutover apply configuration pre-checks fail with error 17131

Views:
82
Visibility:
Public
Votes:
0
Category:
7-mode-transition-tool
Specialty:
dp
Last Updated:

Applies to

  • 7MTT

Issue

  • On attempting to apply configuration in the 7MTT precutover phase, after about 5-10 minutes error 17131 is logged, stating that there are snapmirror transfers in progress for specific volumes and to try again later.
  • When checking the snapmirror relationships for the volumes pointed out in the errror, they were in idle state prior to the attempting precutover and the last transfer was when pre-cutover was attempted. Disabling snapmirror schedules or other changes does not help.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device