Skip to main content
NetApp Knowledge Base

XCP Verify Consistently Shows 'STATUS: FAILED', Though No Failures Found

  1. Last updated
  2. Save as PDF
Views:
257
Visibility:
Public
Votes:
0
Category:
netapp-xcp
Specialty:
nas
Last Updated:

Applies to

NetApp XCP 1.6

Issue

When running 'XCP Verify' the output consistently shows 'STATUS:FAILED', though there are no actual failures

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device

 

  1. Back to top
  • Was this article helpful?

Recommended articles

  1. Article type
    Reference
    Confidence
    Validated
    Flag
    False
    Governance
    Experience
    KCS Enabled
    Yes
    Visibility
    Public
    Product Categories
    NetApp XCP
    Specialty
    NAS
  2. Tags
    1. xcp