Skip to main content
NetApp Knowledge Base

What is promiscuous mode for network card?

Views:
2,063
Visibility:
Public
Votes:
3
Category:
ontap-9
Specialty:
nas
Last Updated:

Applies to

  • ONTAP 9.x
  • Network cards option

Answer

In computer networking, promiscuous mode is a mode for a wired network interface controller (NIC) or wireless network interface controller (WNIC) that causes the controller to pass all traffic it receives to the central processing unit (CPU) rather than passing only the frames that the controller is specifically programmed to receive. This mode is normally used for packet sniffing (running tcpdump for specific interface) that takes place on a router or on a computer connected to a wired network.

Additional Information

In IEEE 802 networks such as Ethernet or IEEE 802.11, each frame includes a destination MAC address. In non-promiscuous mode, when a NIC receives a frame, it drops it unless the frame is addressed to that NIC's MAC address or is a broadcast or multicast addressed frame. In promiscuous mode, however, the NIC allows all frames through, thus allowing the computer to read frames intended for other machines or network devices.

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.