Skip to main content
NetApp Knowledge Base

CIFS share not serving data because the Audit Log Destination is full

  1. Last updated
  2. Save as PDF
Views:
1,819
Visibility:
Public
Votes:
1
Category:
ontap-9
Specialty:
nas
Last Updated:

Applies to

ONTAP 9+

Issue

  • Possible to access a CIFS share, but not possible to open/create files.
  • EMS Messages:
    • adt.dest.directory.full:EMERGENCY Audit destination directory "" of Vserver "
    • adt.service.block:EMERGENCY
  • A message similar to the following is reported when Audit destination directory clients attempt to create a file/folder:
    • There is not enough space on " " The network path was not found

  • Verify the destination is full using the below process:

    1. Determine the audit logs destination: 
      ::> vserver audit show -vserver <vserver name> -fields destination
    2. Determine volume and aggregate for the above destination path: 
      ::> vol show -fields junction-path,aggregate
    3. Check the space usage on the volume and aggregate

::> df -h <volume name>
::> aggr show-space -aggregate-name <aggregate name>

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device