Skip to main content
NetApp Knowledge Base

Snmpconfig command returns "Failed to get snmp config info"

Views:
450
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
brocade
Last Updated:

Applies to

  • All Brocade hardware platforms
  • All Brocade fabric operating system (FOS) platforms

Issue

  • Below error reported while configuring SNMP:

Error: Failed to get snmp config info

  • snmpd showing 94.4% cpu utilization from the top -n 1 output.

<< log snippet >>

PID    USER      PR  NI  VIRT  RES  SHR S %CPU %MEM    TIME+  COMMAND
1470     0         15   0 80284  13m 9.8m S 94.4  1.3   5226:00 snmpd

  • In configshow output of snmp.auditinterval shows as 0 instead of 60.

snmp.auditInterval:0

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.