Skip to main content
NetApp Knowledge Base

Rx/Tx errors on switch interlink after upgrade to 3.9.2400

Views:
216
Visibility:
Public
Votes:
2
Category:
netapp-hci
Specialty:
hci
Last Updated:

Applies to

  • Mellanox SN2010
  • Onyx 3.9.2400
  • NetApp HCI

Issue

  • Rx/Tx errors in (Inter Peer Link) IPL after switch upgrade to 3.9.2400
  • MTU inconsistency
  • WebGUI/CLI will show 9216 MTU but members of port channel HW status show 1522
    • Eth1/20:
        Admin state                      : Enabled
        Operational state                : Up
        MTU                              : 9216 bytes (Maximum packet size 9238 bytes)
    • 20|0x10500     |   Up|   Up|     Plugged|    Speed|0x00B00000|0x00100000|     100GB_CR4|  Post-FEC|  1522
  • Increase in oversize packets on the switch
    • Eth1/20:
        Rx:
           1610                  oversize packets
    • Eth1/22:
       Rx:
          1189                  oversize packets

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.