Skip to main content
NetApp Knowledge Base

Is it possible to use the 4 10Gb/s SFP ports on a Cisco 3132 Interconnect switch?

  1. Last updated
  2. Save as PDF
Views:
256
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
hw
Last Updated:

Applies to

CISCO 3132 Interconnect switch

Answer

The 4 10Gb/s SFP ports can be used to connect existing controllers over copper or optical cable.

Additional Information

Only one between the first 40Gb/s port or the 10Gb/s ports can be enabled at a time.

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device