Skip to main content
NetApp Knowledge Base

What are the Default Management Port IP addresses available on E-Series controllers?

Views:
8,125
Visibility:
Public
Votes:
18
Category:
e-series-systems
Specialty:
esg
Last Updated:

 

Applies to

All E-Series platforms

Answer

The default management port IP addresses for each controller is shown below:

Default IP addresses for all platforms except EF600 running 11.60 or earlier:

Management Port  Controller A Controller B Subnet Mask
1 192.168.128.101 192.168.128.102 255.255.255.0
2 192.168.129.101 192.168.129.102

Note: Default IP addresses are in the form 192.168.XXX.10Y, where:
    XXX = 128 is the first port and 129 is the second port on a controller.
    Y      = 1 is for controller A and 2 is for controller B.

 

Default IP addresses for all platforms running 11.60.2 and later, or EF600 running 11.60 or later:

Management Port  Controller A Controller B Subnet Mask
1 169.254.128.101 169.254.128.102 255.255.0.0
2 169.254.129.101 169.254.129.102

Note: Default IP addresses are in the form 169.254.XXX.10Y, where:
    XXX = 128 is the first port and 129 is the second port on a controller.
    Y      = 1 is for controller A and 2 is for controller B.

The subnet mask for these are running /16, not /24.

Port 2 on the controllers is reserved for Customer Support use only. It should not be used unless explicitly instructed and the default network settings of DHCP enabled should not be changed.

In case of a persistent network configuration issue, please contact NetApp Technical Support and reference this article for further assistance. 

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.