Skip to main content
NetApp Knowledge Base

Switch discovers incorrect E-Series iSCSI host port MAC address during initial setup

Views:
56
Visibility:
Public
Votes:
0
Category:
e-series-systems
Specialty:
esg
Last Updated:

Applies to

  • SANtricity OS 11.73 and below
  • E2800

Issue

  • Network switch reports different MAC address iSCSI host ports on E2800
    • Expected MAC address can be found in Hardware Show back of shelf > click affected controller > Configure iSCSI ports > select desired port > Next
  • ​​​​​​​Incorrect MAC address discovered from switch end could be any of the following:​​​​​​​
    • ​​​​​​​All but the last character is correct
      • ​​​​​​​Example: Expected (reported by SANtricity System Manager) - D0:15:FB:25:E2:B6 and actual (seen on switch) - D0:15:FB:25:E2:B0
    • ​​​​​​​0100.0ccc.ccce
    • ffff.ffff.ffff

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.