Skip to main content
NetApp Knowledge Base

E-Series new replaced drive marked as unassigned and missing from pool configuration

  1. Last updated
  2. Save as PDF
Views:
1,388
Visibility:
Public
Votes:
1
Category:
e-series-systems
Specialty:
esg
Last Updated:

Applies to

  • NetApp E-Series
  • NetApp StorageGRID Appliances
  • NetApp SANtricity version prior to 11.50.3
  • NetApp SANtricity 11.60.2R1

Issue

  • After replacing failed drive, the newly replaced drive shows Unassigned and does not return back to the disk pool:

Status:                  Optimal
Mode:                    Unassigned

  • Recovery GURU shows error:

DISK_POOL_RECONSTRUCTION_DRIVE_COUNT_BELOW_THRESHOLD-Recovery Failure Type Code: 424
DISK_POOL_DRIVE_FAILURE-Recovery Failure Type Code: 443

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device