Skip to main content
NetApp Knowledge Base

E-Series - Unable to assign drive after replacement because it's not a secure  drive

Views:
55
Visibility:
Public
Votes:
0
Category:
e-series-systems
Specialty:
esg
Last Updated:

Applies to

  • NetApp E-Series Secure/Non-secure Drives

Issue

  • Array showing failure VOLUME_GROUP_PARTIALLY_COMPLETE
  • Recently replaced drive showing unassigned and is not able to be assigned after replacement. 
 Drive at Tray 2, Drawer 1, Slot 4
    

      Status:                  Optimal                                          
                                                                                
      Mode:                    Unassigned                                       
      Raw capacity:            1,676.716 GB                                     
      Usable capacity:         1,676.216 GB                                     
      World-wide identifier:   50:00:c5:00:ee:59:f8:b3:00:00:00:00:00:00:00:00  

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.