Skip to main content
NetApp Knowledge Base

Unable to access H410S IPMI via shared port after power drain

  1. Last updated
  2. Save as PDF
Views:
25
Visibility:
Public
Votes:
0
Category:
h-series
Specialty:
hci
Last Updated:

Applies to

  • NetApp H410S
  • No Ethernet cable is connected to IPMI dedicated port
  • Usually use Bond1G ports to access IPMI Web GUI

Note: Using IPMI shared port instead of IPMI dedicated port for ongoing use is not recommended.

Issue

  • IPMI Web GUI does not show up after performing a power drain
  • Response for ping to IPMI IP address is unstable

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.