Skip to main content
NetApp Knowledge Base

LACP bond doesn't recover after bringing port down and then back up on a switch

  1. Last updated
  2. Save as PDF
Views:
296
Visibility:
Public
Votes:
0
Category:
element-software
Specialty:
solidfire
Last Updated:

Applies to

  • NetApp SF19210
  • Element software 12.3.0.958
  • SFP: CISCO-FINISAR SFP-H10GB-AOC5M FCBG110SD1C05-CS
  • Cisco ACI switch
  • LACP rate Fast; LACP suspend individual off

Issue

  • LACP bond doesn't recover after bringing port down and then back up on a switch 
    solidfire_node ~ # cat /proc/net/bonding/Bond10G
Active Aggregator Info:
 Aggregator ID: 1
 Number of ports: 1 (Instead of 2)
  • 10G link on SolidFire side remains UP when the port is Disabled (Administratively Down) on a switch side

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.