Skip to main content
NetApp Knowledge Base

Eth2/Eth3 fimware version should be 3.2d 0x80000b4b 1.1767.0 instead of 3.2d 0x80000b4b 1.1681.0

  1. Last updated
  2. Save as PDF
Views:
179
Visibility:
Public
Votes:
0
Category:
h-series
Specialty:
solidfire
Last Updated:

Applies to

H610S

Issue

After the node is replaced, the below alerts are detected

nodeHardwareFault "Hardware fault ID 826 text=NETWORK_FIRMWARE_VERSION_ETH2 should be == 3.2d 0x80000b4b 1.1767.0 but is 3.2d 0x80000b4b 1.1681.0"
nodeHardwareFault "Hardware fault ID 827 text=NETWORK_FIRMWARE_VERSION_ETH3 should be == 3.2d 0x80000b4b 1.1767.0 but is 3.2d 0x80000b4b 1.1681.0"

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.