Skip to main content
NetApp Knowledge Base

ONTAP Select Single node cluster not seen as part of the cluster after power cycle

  1. Last updated
  2. Save as PDF
Views:
29
Visibility:
Public
Votes:
0
Category:
ontap-select
Specialty:
ontapselect
Last Updated:

Applies to

  • ONTAP Select single-node cluster
  • ONTAP 9.16.1
  • VMware ESXi hypervisor environment

Issue

  • The cluster was down for an extended period, and the power-off cause is unknown.
  • After powering theONTAP Select single node cluster, the following symptoms are observed:
    • Only management connectivity (mgmt LIF) is available
    • System Manager access is not possible.
    • No SVMs/vServers, volumes, data LIFs, or cluster LIFs are visible from the ONTAP CLI.
    • The node is not seen as part of the cluster, and cluster-related CLI commands are unavailable.
    • CLI commands such as cluster show, vserver show, and volume show return: Error: "show" is not a recognized command

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.