Skip to main content
NetApp Knowledge Base

sync losses on ATTO FiberBridge FC port after cable replacement

  1. Last updated
  2. Save as PDF
Views:
121
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
MetroCluster
Last Updated:

Applies to

  • ATTO 6500N FibreBridge
  • ATTO 7500N FibreBridge
  • ATTO 7600N FibreBridge
 

Issue

  • High count of sync loss reported for FC port in Fiberbridge

get FCPortErrors all

; Fibre Channel Error Counts
; Port | Link Failures | Sync Loss | Signal Loss | Invalid Tx | Invalid CRC
;==========================================================================
   1                 2          212            0          448             0
   2                 2           3             0            8             0

Ready.
====================================

  • The optical cable between the affected bridge port and the switch has been replaced.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.