Skip to main content
NetApp Knowledge Base

Where do I need to run the controller replacement start command?

  1. Last updated
  2. Save as PDF
Views:
131
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
hw
Last Updated:

Applies to

ONTAP 9.10.1 and later

Answer

To initiate a controller replacement at site A, you need to run the controller replacement start command from site B. The operation guides you to replace controllers of both the nodes at site A only. To replace the controllers at site B, you need to run the controller replacement start command from site A. A message displays identifying the site at which the controllers are being replaced.

Additional Information

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.