Skip to main content
NetApp Knowledge Base

Unable to assign remote drives during MetroCluster FC to IP transition

  1. Last updated
  2. Save as PDF
Views:
41
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
MetroCluster
Last Updated:

Applies to

  • ONTAP 9
  • MetroCluster FC to IP transition
  • Manual disk assignment
  • Asymmetric aggregates on both clusters
  • Fully populated shelves

Issue

During MetroCluster FC to IP transition when attempting to assign a remote drive the following error is seen:
 
Example:

ClusterA::*> disk assign -disk 10.10.0 -pool 1 -owner ClusterA_N3
Error: command failed: Failed to assign disks. Reason: Cannot assign "10.10.0" from this node. Try the command again on node "ClusterB_N4".

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.