Skip to main content
NetApp Knowledge Base

Stale vlan ID still shows up during a new setup of MetroCluster IP

  1. Last updated
  2. Save as PDF
Views:
86
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
MetroCluster
Last Updated:

Applies to

  • MetroCluster IP (MCCIP)
  • ONTAP 9

Issue

  • The default VLAN ID (vlan10 and vlan 20) is used when initially installing MCCIP using System Manager
  • The MCCIP is then initialized and re-setup with a custom VLAN id.
  • MCCIP setup (metrocluster configuration-settings interface create ) failed because the stale vlan ID still shows up 

Note: Set-defaults , 9a) cleaning disk, and 4) init ontap are already been done, but the problem persists.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.