Skip to main content
NetApp Knowledge Base

Should unmirrored aggregates in a fabric attached MetroCluster be local?

  1. Last updated
  2. Save as PDF
Views:
537
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

​ ​ ​  

Applies to

  •  MetroCluster
  • Fabric attached
  • Unmirrored aggregates

Answer

Using unmirrored aggregates in fabric attached MetroCluster system, all disks from this aggregate should be local to the node owning the aggregate but attached through the fabric and visible to all nodes in the MetroCluster.

Verify which disks are not local to the system by executing the 'disk show -aggregate <aggregate> -fields is-local-attach' command.

siteA::> disk show -aggregate <aggregate> -fields is-local-attach
disk is-local-attach
------- ---------------
3.22.13 false
3.22.14 false
3.22.15 false
3 entries were displayed.

Verify if the aggregate is intended to be mirrored and mirror it.

Note: ​There are several different options for addressing this issue which might require careful analysis of your system.
Reach out to your account team or NetApp Support for information on how to address this configuration.

Additional Information

Add your text here.

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.