Skip to main content
NetApp Knowledge Base

MetroCluster-"Aggr Delete" completed unsuccessfully,Failed to remove the location information

  1. Last updated
  2. Save as PDF
Views:
535
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

  • ONTAP
  • MetroCluster

Issue

After deleted the only one data aggregate on a node of MCC system, the aggregate name sill shows in the output of "aggr show"  with "unknown" state.

MCC2::*> aggr show
Aggregate     Size     Available  Used%  State   #Vols Nodes   RAID  Status
---------    --------  ---------  -----  ------  ----- ------- -------------
aggr0_MCC2_01 1.40TB   69.36GB    95%    online   1    MCC2-01 raid_dp, mirrored,normal
aggr0_MCC2_02 1.40TB   69.36GB    95% online      1    MCC2-02 raid_dp, mirrored,normal 
aggr1_MCC2 - - -unknown - MCC2-01 -
3 entries were displayed.
 
Command "aggr remove-stale-record" does not works 
 
MCC2::*> aggr remove-stale-record -aggregate aggr1_MCC2 -nodename MCC2-01
Error: command failed: The specified aggregate "aggr1_MCC2" does not correspond to a stale aggregate record. Use the "storage aggregate delete" command to delete this aggregate.
 
EMS shows error messages:
 
[MCC2-02: mgwd: mgmtgwd.jobmgr.jobcomplete.failure:info]: Job "Aggr Delete" [id 132] (Delete aggr1_MCC2) completed unsuccessfully: Failed to remove the location information of aggregate aggr1_MCC2 from VLDB due to The MetroCluster or Vserver DR Configuration Replication Service is recovering. Issue the "metrocluster check config-replication show -instance" command or the "snapmirror config-replication status show" command and follow its guidance. If there is no guidance, wait a few minutes and then try the command again.. . Retry later. (1).

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.