Skip to main content
NetApp Knowledge Base

How to switch the ONTAP Health Monitoring of an ATTO FibreBridge to in-band in 9.5 and later

  1. Last updated
  2. Save as PDF
Views:
9,077
Visibility:
Public
Votes:
10
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

  • ONTAP 9.5+
  • Fabric MetroCluster
  • ATTO FibreBridge 7500N/7600N

Description

  • Starting in ONTAP 9.5, the usage of in-band management for monitoring the ATTO 7500N and 7600N FibreBridge is advised
  • This article describes how to leverage in-band management
  • If an ATTO FibreBridge is replaced this procedure can be used to add the replacement bridge to in-band monitoring rather than IP based monitoring

Additional Information

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.