Skip to main content
NetApp Knowledge Base

Fail to add FibreChanel Switch for monitoring with SNMPv1 due to missing public community

  1. Last updated
  2. Save as PDF
Views:
48
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

ONTAP 9

Issue

  • Fail to add Fibre Channel Switch with following error.

yyyy::*> system switch fibre-channel add -address xx.xx.xx.xx -snmp-version SNMPv1       

Error: command failed: Internal error. Failed to add switch for monitoring on node "yyyy-01" in cluster "yyyy". Reason: Failed to check if device located at "xx.xx.xx.xx" is from supported vendor. For
       further assistance, contact technical support.

  • Node Management LIF can reach to Fibre Channel Switch.
  • SNMPv1 is enabled.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.