Skip to main content
NetApp Knowledge Base

ATTO bridge update failed with error "Some devices can only be accessed through this bridge."

  1. Last updated
  2. Save as PDF
Views:
61
Visibility:
Public
Votes:
2
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

  • MetroCluster FC
  • ATTO Bridge upgrade
  • ISL down

Issue

Updating an ATTO bridge fails with error:

Error: command failed: Device operation failed on bridge "2000001234abcd12". Some devices can only be accessed through this bridge.
Verify paths to the bridge, and then wait until at least 2 paths are available or use the "-skip" parameter to ignore checks and download firmware to the bridge.

 

 

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.