Skip to main content
NetApp Knowledge Base

fcp topology show and fcp adapter show command timeout in ONTAP

  1. Last updated
  2. Save as PDF
Views:
283
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
san
Last Updated:

Applies to

  • ONTAP 9.9.1
  • ONTAP 9.10.1
  • ONTAP 9.11.1
  • Cisco enhanced zoning
  • FCP

Issue

  • Running commands FCP adapter show  and fcp topology show timeouts

network fcp adapter show -node node1 -adapter 2a
Error: show failed: Timeout while getting fabric information

  • Get Active Zone Set (GAZS) may show failed when requested by ONTAP node 

[NODE01: fct_tpd_work_thread_0: scsitarget.hwpfct.mserr:debug]: The Fibre Channel fabric management server request (GAZS) sent from adapter 0e failed with reason code 0x0 (Succeeded), explanation code 0x0 (No additional data), and response code 0x0.

  • Rebooted hosts may lose access to LUNs

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.