Skip to main content
NetApp Knowledge Base

Unable to remove the source array from Ontap due to zoning still present on switch end

  1. Last updated
  2. Save as PDF
Views:
57
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
san
Last Updated:

Applies to

  • Offlline FLI Migration
  • SAN
  • Ontap 9.x

Issue

  • LUN is migrated from 3rd party storage vendor to Ontap using offline FLI migration.
  • Post removing the LUN from 3rd party storage an error is received on Ontap, storage disk show output shows that the array LUN is failed with the container type as broken

  • Received error "one or more of the array's target ports are still connected to the cluster" while trying to remove the source array from ontap CLI using storage array remove command

            storage array remove.png

  • To display all visible source arrays run storage array show.
    cmode::> storage array show
    Prefix Name Vendor Model Options
    Hx-1 HxxxI_DxcxcF_1 HxxxI Dxccx0F

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.