Skip to main content
NetApp Knowledge Base

SnapMirror Mediator disconnected from GUI but connected via CLI

  1. Last updated
  2. Save as PDF
Views:
31
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
san
Last Updated:

Applies to

  • ONTAP
  • SnapMirror Active Sync (SM-as )

Issue

  • After certificate SnapMirror active sync mediator appears disconnected from the GUI but shows as connected from the command line interface (CLI)
  • One of the ONTAP clusters does not have a connection to the mediator
Example:
::*> set d;rows 0;snapmirror mediator show -instance
::*> network interface show -role node-mgmt,cluster
::*>network ping -node node_1 -destination 192.168.0.1 -verbose -record-route -show-detail
::*> network ping -node node_1 -destination 192.168.0.1 -verbose -services management-https -record-route -show-detail
::*> network ping -node node_1 -destination 192.168.0.1 -verbose -services management-ssh -record-route -show-detail
 
Mediator: 
systemctl status ontap_mediator mediator-scst
netstat -anlt | grep -E '3260|31784|22'
ping  <node and cluster managment LIF's IP from above >
telnet  <IP> 31784
telnet  <ip> 22

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.