Skip to main content
NetApp Knowledge Base

LUNs are not visible on host end due to conflict of zoning on UCS switches

Views:
37
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
san
Last Updated:

Applies to

  • Ontap 9
  • Cisco UCS switch

Issue

  • LUNs are not visible on host end while configuring new hosts with new Cisco UCS.
  • Zone is attached to Service profile on old switches where LUNs were accessible.
  • Service profile on old switches do not have zoning profile.
  • However, for new UCS switches zoning profile was configured.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.

 

  • Was this article helpful?