Skip to main content
NetApp Knowledge Base

Error Loss of LUN path redundancy and possibly data access

Views:
192
Visibility:
Public
Votes:
0
Category:
aff-series
Specialty:
san
Last Updated:

Applies to

  • ONTAP
  • FlexPod
  • CISCO UCS

Issue

  • FCP target Port/Path showing status disconnected with following command shows low receive optical power

fcp adapter show -instance -node abc -adapter 1x

  • Following switch command shows status error disabled bit error rate too high

show interface brief

show interface

show logging log

  • Following UCS command shows port-channel on fabric interconnect down

show fault

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.