Skip to main content
NetApp Knowledge Base

quota show command returns The specified qtree does not exist

  1. Last updated
  2. Save as PDF
Views:
154
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
nas
Last Updated:

Applies to

  • ONTAP 9
  • Quotas
  • PowerShell Toolkit

Issue

  • If a qtree is deleted through the ONTAP CLI, the corresponding quota rule will also be automatically deleted
  • However, if the qtree is deleted via the Powershell toolkit, the corresponding quota rule will remain there, leading to the following error message when the subsequent quota show command is executed
Last Error : The specified qtree does not exist. (type : tree target:xxxxx qtree:””).

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.