Skip to main content
NetApp Knowledge Base

How to disable IPv6?

Views:
172
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
nas
Last Updated:

Applies to

  • ONTAP 9
  • IPv6

Answer

  • You may receive the following error message if attempting to disable IPv6:

::> network options ipv6> modify -enabled false
 
Error: command failed: Once enabled, IPv6 support cannot be disabled.

Disabling IPv6 is a diagnostic command:

::> set diag

::*> network options ipv6 modify -enabled false

Additional Information

network options ipv6 modify

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.