CLI reports that upgrade is not complete due to aborted Snapmirror task
Applies to
- ONTAP 9
- ANDU
- Snapmirror
Issue
- After and upgrade is performed, and both nodes reboot, the following message is seen at CLI:
***********************
** SYSTEM MESSAGES **
***********************
The upgrade of this node is in progress or not completed. The ability to provide
data service to clients is not affected while the upgrade completes. You can
check on the status of the upgrade by running "system node upgrade-revert show"
in advanced privilege mode. The status for this node should be listed as
'complete'. If the upgrade has stopped, you can restart the upgrade by running
"system node upgrade-revert upgrade" in advanced privilege mode. If this command
does not complete the node's upgrade, contact technical support immediately. The
node will be ready for management operations once the upgrade is completed
successfully.
- When checking the cluster version, the previous version is shown
cluster::*> version
<old_cluster_version>
Info: The output from the version command above may not be correct because
upgrade is in progress or has failed in one or more nodes in the cluster.
Use the "upgrade-revert show" command in advanced mode to view the status
of upgrade.
- The below status is seen when checking "system node upgrade-revert":
cluster::*> system node upgrade-revert show -node node-01
Node: node-01 Status: aborted
Status Message: The upgrade aborted in the "post-apps" phase on task "SnapMirror 9.16.1 Upgrade/Revert Task". Contact support personnel for the upgrade repair procedure.
Vers Phase Status Upgrade Phase Status Message
---- ---------- -------- ------------------------------------------------------
2000 pre-root applied No upgrade is required for this phase.
2000 pre-apps applied Upgrade successful.
2000 post-apps applied Upgrade successful.
2200 pre-root applied No upgrade is required for this phase.
2200 pre-apps applied Upgrade successful.
2200 post-apps applied Upgrade successful.
2400 pre-root applied No upgrade is required for this phase.
2400 pre-apps applied Upgrade successful.
2400 post-apps applied Upgrade successful.
2800 pre-root applied No upgrade is required for this phase.
2800 pre-apps applied Upgrade successful.
2800 post-apps aborted entry doesn't exist
cluster::*> system node upgrade-revert show -status aborted
Node: node-n1 Status: aborted
Status Message: The upgrade aborted. Contact support personnel for the upgrade repair procedure.
Vers Phase Status Upgrade Phase Status Message
---- ---------- -------- ------------------------------------------------------
1100 post-apps aborted entry doesn't exist