Skip to main content
NetApp Knowledge Base

What does the 'cluster' displayed in the 'statistics system show' command indicate?

  1. Last updated
  2. Save as PDF
Views:
108
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
perf
Last Updated:

Applies to

Answer

  • It refers to a general-purpose cluster.
  • Since the -system parameter can only specify cluster in practice, there is little meaning in using it.

Example:

aff220-2n-rtp-2::*> statistics system show -system ?
  cluster

aff220-2n-rtp-2::*> statistics system show -iterations 0

aff220-2n-rtp-2 : 9/6/2024 00:52:55

        CPU *Total Total Latency
 System (%)    Ops (Bps)    (us)
------- --- ------ ----- -------
cluster   2      0     0       0

aff220-2n-rtp-2 : 9/6/2024 00:52:59
cluster   2      0     0       0

aff220-2n-rtp-2 : 9/6/2024 00:53:03

        CPU *Total Total Latency
 System (%)    Ops (Bps)    (us)
------- --- ------ ----- -------
cluster   2      0     0       0
......
 

Additional Information

CONTAP-329466 '-system' parameter of 'statistics system show' command can only specify 'cluster' in practice,
NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.