Skip to main content
NetApp Knowledge Base

What happens if the storage system is rebooted while Wafliron is running

  1. Last updated
  2. Save as PDF
Views:
260
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
core
Last Updated:

Applies to

  • ONTAP 9

Answer

If the storage system reboots while Wafliron is running, it will need to be started using the storage aggregate wafliron start command. However, the point at which the Wafliron starts following the power cycle depends on what phase it was in at the time of the reboot.

If Wafliron is stopped in:

  • Phase 1 (Mount), it must start from the beginning. 
  • Phase 2 or 3, any changes committed to the point of reboot will be retained, but Wafliron will start scanning again in Phase 1 wafliron start command.

 

Additional Information

additionalInformation_text

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.