Skip to main content
NetApp Knowledge Base

Root Aggregate and root volume are not listing for new nodes in cluster

  1. Last updated
  2. Save as PDF
Views:
237
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
core
Last Updated:

Applies to

  • ONTAP 9
  • Cluster-join or Node-Join
    • This KB is only for situations where cluster/node-join was performed recently and reported nodes are newly added nodes.

Issue

  • On newly added nodes in the cluster: Root aggregate and volume are not listing in clustershell when running aggr show and vol show command.
  • Root aggregate and volume will be present in nodeshell but not populating in clustershell due to discrepancies.
  • To verify on newly added nodes:

::> run -node <newly added node> aggr status

::> run -node <newly added node> vol status

::> run -node <newly added node> df

::> run -node <newly added node> df -a

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.